P18-100-12

SKU : P18-100-12

P18-20A Series 100A Data Sheet : Download / Main Catalogs : Download 

Body Color : Red, Yellow, Blue, Green, Black

Rate current : 100A, Max. : 120A. / Secondary current : 100mA. / Coil ratio : 1000:1 Burden Resistant : Customized / Accuracy : 0.2% 

P18 100A VOLTAGE OUTPUT 2M HZ BANDWIDTH CLASS 0.1 AC CURRENT CLAMP 

The round jaw design on the P18 Series AC current clamp along with the high content nickel metal core makes them well suited for power quality applications where high accuracy and low phase shift along with wide frequency are important. Measurement range is 1mA to 120A. The P18 is a general purpose 100A AC current clamp designed for use with DMMs, power loggers and energy meter calibration instruments that have a current input. It has a 1000:1 ratio and output of 1mA per amp or 1mV per amp measured in the jaw. The P18 has an integral 2.5m lead terminated. The rounded jaw design on this current clamp makes it well-suited for power applications where high accuracy 0.1% and low phase shift and wide frequency response are important. 

APPLICATIONS 

• Power quality analyzer(PQA) 
• power and harmonic meters 
• Phase angle meter 
• Energy meter calibrator 
• Measuring around cable bundles 
• Power load monitoring 
• Data logging/recording 
• Waveform analysis(oscilloscopes meter) 

FEATURES 

• Measurement range of 1mA to 120A AC 
• Improved ergonomic design & easy operation 
• High content nickel metal permalloy core 
• Frequency 10Hz-2MHz Bandwidth 
• Holding wire diameter: φ18mm 
• Conforms to EN 61010, 600V CAT III 
• Low phase shift for power measurement 
• Designed for DMMs, recorders, loggers, oscilloscopes, power and harmonic meters 
• UL, CE mark

 Electrical parameters 

• Ratio : 1000: 1 or 2000:1 (customized) 
• Accuracy class : 0.1%, 0.2% 
• Primary current : 0 - 100A AC or 0-200A AC 
• Secondary current : 0 - 100mA AC or 0 - 200mA AC (customized) 
• Secondary voltage : 0 - 100mV AC, 0 - 1V AC or 0-5V AC (customized) 
• Max. Cont. Input current : 120A or 240A 
• Load capacity : ≤4Ω 
• Over voltage category : CAT III 600V 
• Output signal (AC current) : From 0 to 200mA AC at nominal input current 
• Output signal (AC voltage) : From 0 to 5V AC at nominal input current 
• Frequency range : 10Hz-2MHz 
• Dielectric strength : 3KV 50Hz/60Hz at 1minute 
• Temperature range : -40°C to +55°C 
• Output : 2.5 meter cable with D01 or BNC connector 
• Max. voltage not insulated conductors : 600 V 
• Standard : EN 61010-1, EN 61010-2-032, IEC60044-1 
• Installation : clamp type 
• Output mode :lead output(2.5m, 5m or 10m) 

Mechanical parameters 

• Dimensions (L x W x H) (mm) : 52.5 x 137.5 x 28 
• Weight (g) : 400 
• Holding wire diameter (mm) : φ18 
• Max. jaw opening (mm) : 18 
• Jaw color : Red, yellow, blue, green, black 
• Material : PC+ABS, UL94 V0 

MOQ. 3Ea.